Posted by: jojo | Date: 2019-06-04 16:39 | IP: IP Logged
Using PSPad 32-bit version 5.0.1 (312) on Windows 10 Professional x64, I can reliably crash the application by opening a file in hex editor mode and then just keeping a key pressed to overwrite a sequence of bytes. After a while, I either get an access violation message box or the application just shuts down without any notice. The amount of bytes after which this occurs differed on two machines I tested this on, sometimes it was after less than 64 bytes, in other cases it took up to overwritten 256 bytes until the application would crash.
Posted by: pspad | Date: 2019-06-04 17:06 | IP: IP Logged
Can you repeat your problem with version 5.0.2? Available in developer forum
Posted by: jojo | Date: 2019-06-04 20:12 | IP: IP Logged
It also crashes with version 5.0.2 321 (32-bit).
Posted by: pspad | Date: 2019-06-05 03:48 | IP: IP Logged
Can you send me the exception log to the support mail?
Posted by: jojo | Date: 2019-06-05 06:56 | IP: IP Logged
Unfortunately the crash dialog doesn't show up as the application just shuts down immediately. Is there another way to generate a log for you?